Repeating cuts made using a miter saw is simple enough, but measuring and marking seldom yields pieces of equal size. For better outcomes, this Old House diy Expert as well as House One editor Jenn Largesse offers three simple methods to cut multiple pieces.
How to make multiple cuts using a Miter saw
1. Utilize to use the First Cut as a Template
The most straightforward option is to use your first cut board to measure the cut that follows. You can do this simply by placing your cutboard on the top of the uncut board with the edges in a straight line.
The blade is lowered slightly and then move between the boards till the cutting boards are on the blade’s side Remove the board, and make the cut.
It is important to continue the same board in use and not the latest cut one, so that the measurement doesn’t “grow” with time. The disadvantage of this method is that the blade may cut a little more of the next cut therefore there is the potential for some variation.
2. You can cut multiple boards at the same At the Same
Another method to create repeat cuts is by using “gang cut” or cut several boards simultaneously. To accomplish this, place the boards so that their ends are in a straight line and then cut each piece with a single cut. The benefit is that you’ll get perfectly level cuts.
3. Create an Stop Block
The third and most reliable option is to create the stop block. To accomplish this, cut your first cut. Lower the blade and secure it in the desired position.
Move the stop block towards the cutting board, and then clamp it on the fence or the surface of work. Then, raise the blade, unclip the board, then move an uncut part into position to begin your next cut.
The advantage of this is well-cut pieces that have the least amount of error however, the drawback is that it can be difficult if the saw that has been that has been turned into a miter-station with levels planes on both sides or if the boards are too large to allow an obstruction block in the area on the surface of your station.
